Filter
Top Products
Before using for the first time
6
Before using for
the first time
Before operating the remote control unit, install two
batteries.
1
While pushing the tab of the rear cover,
remove the rear cover from the remote control
upwardly.
2
Install batteries. Be sure that the batteries are
installed with correct polarity, (+) and (–).
3
While aligning the end of the rear cover with
the remote control, assemble the rear cover on
the remote control by pushing it downwardly.
Battery replacement
Service life of batteries depends on the condition of use;
standard life is about one year. When the batteries
become weak, the operating distance of the remote
control unit becomes short. If this happens, replace the
batteries R6P(SUM-3)/AA(15F) with new ones.
COMPU LINK connection
JVC’s COMPU LINK Remote Control System provides
unified control over system components connected with
COMPU LINK. Connecting JVC audio components with
the COMPU LINK jacks automatically controls relative
operations between components and facilitates various
operations. With the COMPU LINK connection to an
amplifier or receiver, you can operate XL-FZ700BK with
the amplifier or receiver’s remote control unit.
Synchronized recording is also available with this
feature.
Connecting the COMPU LINK cord
The COMPU LINK-3 (SYNCHRO) jacks are used to output
and input the control signal for the COMPU LINK remote
control system.
COMPU LINK-compatible products are provided with the
jacks marked COMPU LINK-1, COMPU LINK-2 or COMPU
LINK-3, referring to the COMPU LINK version. XL-
FZ700BK is equipped with COMPU LINK-3. You can
connect XL-FZ700BK also to a component with lower
COMPU LINK versions. But, in that case, only the lower
versions’ features will be available.
Plug the supplied COMPU LINK cord into the COMPU
LINK-3 (SYNCHRO) jack on the rear panel of XL-FZ700BK.
Plug the other end into the COMPU LINK jack of the other
component. If there are two COMPU LINK jacks, plug it
into either of them.
Connect to the COMPU LINK-3 (SYNCHRO) jack of
another component equipped with the Compu Link
remote control system.
To install the batteries in the remote
control unit
NOTES
Incorrect use of batteries can cause corrosion or damage.
Note the following points to lengthen battery life.
• Install batteries observing the correct polarity, (+) and (–).
• Do not use new and old batteries simultaneously.
• Batteries with similar shapes may have different
voltage ratings. Be sure to use the correct batteries.
• Remove batteries from the remote control unit if it will
not be used for a long period of time.
• Do not expose batteries to heat or flame.
NOTE
• The lower the temperature, the shorter the battery life.
Rear panel of this unit
Amplifier or receiver
Cassette deck
Turntable
COMPU LINK cord*
* Only one COMPU LINK cord is supplied.
XL-FZ 700BK(UJ).book Page 6 Friday, April 19, 2002 6:05 PM