Filter
Top Products
2
Introduction
Introduction
Precautions
Load compact discs only
Never insert anything other than compact discs into any
part of the player.
If a problem persists
If something goes wrong, turn off the power
immediately. If the same problem reoccurs when the
power is turned on once more, turn off the power again
and consult your JVC dealer.
Handling the power cord
When unplugging from the wall socket, always pull the
plug body, never the power cable.
Volume settings
A CD player has almost zero background noise. Because
of this, the technique of listening to the background level
and then setting the volume before the music starts, as
used with analog turntables or tape decks, cannot be
used. If you raise the volume level too high, speaker
damage may result.
Condensation
The CD player uses optical components. If it is moved
from a cold location to a warm one, or is used in a room
subject to excessive humidity or where a fire has just
been lit, condensation could form on the optical
components.
This may prevent the laser beam from being properly
transmitted and thus causes noise or even a
malfunction.
If condensation has formed and the CD player does not
function correctly, we recommend that you leave it
turned on for an hour or two. If at the end of this time the
CD player still does not function properly, please consult
your JVC dealer.
Using compact discs
Compact discs are made of plastic and can easily be
damaged. If the disc is dirty, scratched, warped or
otherwise damaged, the digital information may not be
picked up correctly.
Applicable discs
This unit can only be used with compact discs bearing
the marks below. Never use discs of other types.
CD-R and CD-RW discs recorded with the Audio CD format
can be played back, though some may not be played back
because of the disc characteristics or recording condition.
About this manual
This manual covers the operating instructions for the
compact disc automatic changer XL-FZ700BK.
This manual is organized as follows:
The first part, “Introduction”, gives you the precautions
when using this unit, and shows you the names of
buttons on the main unit and the remote control unit.
The second part, “Before using for the first time”, tells
you what kind of operations you should do before
playing discs. This part describes where to place the unit
for best results, how to install batteries in the remote
control unit and how to connect this unit to the amplifier/
receiver and other components.
The third part, “Basic operations”, describes how to load
discs, and convenient basic functions for playing discs.
The fourth part, “Various playback patterns”, describes
various functions for playing discs.
The fifth part, “General informations”, describes the
COMPU LINK remote control system which facilitates
various operations between JVC components, and
explains how to take care of discs.
This part also includes “Troubleshooting”, which tells
you how to check the unit when a malfunction occurs,
and the technical informations regarding this unit.
Transporting the unit
When carrying this unit, it is best to avoid either
tilting or turning it upside-down. When you cannot
avoid doing so, please remove the discs first.
NOTE
• CD-R and CD-RW discs must be finalized.
Recordable
ReWritable
XL-FZ 700BK(UJ).book Page 2 Friday, April 19, 2002 6:05 PM