Filter
Top Products
– 17 –
Recording a Tape on Deck B
On the unit ONLY:
1
Press EJECT 0 for deck B.
2
Put a recordable cassette in, with the exposed
part of the tape down and the side you want
to record facing front.
3
Close the cassette holder gently.
4
Start playing the source—FM, AM, CD
player or auxiliary equipment connected to
AUX IN jacks.
• For duplicating tapes, see “Dubbing Tapes” on page 18.
• For recording from CD, see “CD Synchronized
Recording” on page 18.
5
Press REC START/STOP.
The REC (recording) indicator lights up on the
display and recording starts.
To stop during recording, press REC START/STOP again
or 7.
To remove the cassette, press EJECT 0 for deck B.
Recording
IMPORTANT:
• It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or video
recording, broadcast or cable program and in any
literary, dramatic, musical, or artistic embodied
therein.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME, the ACTIVE BASS EX.
LEVEL, and the SOUND MODE controls. Thus, during
recording you can adjust the sound you are actually
listening to without affecting the recording level.
• While recording, you can hear sound modes through the
speakers or headphones. However, the sound is recorded
without these effects (see page 10).
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Place the unit away from
the TV.
• You can use type I tape for recording.
To protect your recording
Cassettes have two small tabs
on the back to protect
unexpected erasure or re-
recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
To keep the best recording and playback sound quality
If the heads, capstans, and pinch rollers of the cassette decks
become dirty, the following will occur:
• Impaired sound quality
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
To clean the head, capstan, and pinch roller
Use a cotton swab moistened with alcohol.
To demagnetize the head
Turn off the unit, and use a head demagnetizer (available at
electronics and audio shops).
Head
Capstan
Pinch roller
Erase head
REC START
/STOP
CD
ST
EN17-24.MX-K50[J].pm6 02.2.18, 8:21 PM17