Filter
Top Products
6
Getting Started
English
Connecting the AM Antenna
Rear Panel of the Center Unit (CA-
FSX1/CA-FSX3)
• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord.
This could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop
antenna connected.)
Attach the AM loop to its base by snapping the tabs on
the loop into the slot in the base.
AM loop antenna (Supplied)
Turn the loop until you have the best reception.
Outdoor single vinyl-covered wire (not supplied)
FS-X1-3(UW)_E.book Page 6 Thursday, April 10, 2003 4:06 PM