Filter
Top Products
17
Using the CD Player
English
❑ You can insert a CD while listening to the other source.
• However, while the CD door is operating (opening or
closing), the other source will be muted.
CAUTION:
• DO NOT try to open or close the CD door by
hands as it will be damaged.
To Unload a CD
Take out the CD as shown below.
Basics of Using the CD Player
– Normal Play
To Play a CD
1
Select the source “CD”.
2
Insert a CD.
3
Press the
6
button on the Unit or the
CD
6
button on the Remote Control.
The first track of the CD begins playing.
• The CD Player automatically stops when the last
track of the CD has finished playing.
To stop playing the CD, press the 7 button.
The following information for the CD is displayed.
To stop playing and remove the CD, press the 0CD
button on the Unit or the CD DOOR 0 button on the Re-
mote Control to open the CD door.
To pause, press the
6
button on the Unit or the CD 6
button on the Remote Control. The playback time blinks on
the display.
To cancel pause, press the same button again. Play con-
tinues from the point where it was paused.
To Select a Track or Passage within a Track
During playback
Press the ¢ or 4 button on the Unit or the 3 or 2 but-
ton on the Remote Control to select the track you want.
• The selected track starts playing.
• Press the ¢ (or 3) button once to skip to the
beginning of the next track.
• Press the 4 (or 2) button to skip to the beginning
of the track being played. Press twice quickly to skip
to the beginning of the previous track.
• When the 3 or 2 button on the Remote Control is
kept pressing, the track continuously skips.
• Press the Numeric Keys to select truck number (See
page 12).
In Stop mode
• Press the ¢ or 4 (or 3 or 2) button to skip the
track.
• Hold down the ¢ or 4 (or 3 or 2 ) button to
continuously skip the tracks.
Search Play
Holding down the ¢ or 4 button on the Unit or the 5
or ∞ button on the Remote Control, during playback, will
fast forward/backwards the CD so you can quickly find a
particular passage in the track you are listening to.
Programming the Playing Order
of the Tracks – Program Play
You can program up to 32 tracks in any desired order in-
cluding the same tracks.
❑ You can only make a program when the CD Player is
stopped.
On the Remote Control
1
Insert a CD.
2
Press the CD
6
button.
3
Press the
7
button to stop the CD.
4
Press the FM/PLAY MODE button until
“CD PROGRAM” appears.
The System enters the Program Play mode and the
“PRGM” indicator lights up.
Each time you press the button, the play mode changes
as follows.
CD PROGRAM=CD RANDOM=CD NORMAL=
(back to the beginning)
• If already programmed, the track number and preset
number of the last programmed track will appear.
Track number Playback time
Total track number Total playback time
(After a few seconds)
FS-X1-3(US)_E.book Page 17 Friday, April 18, 2003 7:27 PM