Filter
Top Products
8
English
■■
Using the Powered Subwoofer
VOLUME
PHASE
POWER
INPUT (LOW-LEVEL)
INPUT (HIGH-LEVEL)
AUTO POWER
ON/STANDBY
indicator
Presetting the Volume ———————
You need to preset the volume level of this speaker to match those
of the other speakers. Once you preset the volume level, it is stored
as your reference level and the volume level of this speaker will be
able to automatically change as the volume level of the Unit chang-
es.
■
1. Press the POWER button of the Subwoofer
to turn on the power.
The ON/STANDBY indicator of the Subwoofer will light in
green.
■
2. Set the VOLUME in the “MIN” position.
■
3. Adjust the volume of the Unit to your lis-
tening level.
■
4. Adjust the VOLUME to balance the volume
with the other speakers.
To turn off the Subwoofwer, press the POWER switch to light
off the ON/STANDBY indicator.
Note: When adjusting the VOLUME, be sure the “BASS” indica-
tor on the Unit is lit, indicating that the subwoofer level is
set to normal. If not, press the BASS CONTROL button on
the Unit to light it up.
Adding the Richness to the Bass
(PHASE) ——————————————
If you want to add the richness more to the bass, press the PHASE
button to set it either in the “
_ REVERSE” position or the “— NOR-
MAL” position, whichever can add the richness to the bass.
Normally, the PHASE button should be set in the “— NORMAL”
position.
Automatic Operating Status On/Off
To save energy, the Subwoofer enters the Standby mode if no (or
very weak) sound signals come into the Subwoofer for about 5 min-
utes. In Standby mode, the ON/STANDBY indicator of the Sub-
woofer lights in red.
When sound signals come in again, the Subwoofer enters the Oper-
ating mode and reproduces the sounds. The ON/STANDBY indica-
tor will light in green again.
CAUTION: Be sure to turn off the POWER of the
Powered Subwoofer when the Powered Subwoof-
er is not in use for an extended period of time.
INPUT Terminals ——————————
The Subwoofer has the following INPUT terminals.
INPUT(LOW-LEVEL):
Usually, the LEFT/MONO terminal is connected to the SUB-
WOOFER OUT terminal of the Unit with the supplied signal cord.
(see page 4)
Operating the Powered
Subwoofer
When CA-FS8000 is not used
(Using other equipment)
If an unit to be connected does not have the SUB WOOFER
OUT terminals, the RIGHT and LEFT/MONO terminals will
be connected to the LINE OUT-RIGHT and LEFT terminals of
that unit.
INPUT (HIGH-LEVEL):
You can connect the speaker output terminals of other unit to
these terminals.
Connect the speaker cords in parallel to the speaker terminals
on the component system etc.
Note: Do not use the INPUT (LOW-LEVEL) terminals at the
same time.
LINE OUT
LEFTRIGHT
Connecting cord
(not supplied)
AMP
SPEAKER
LEFTRIGHT
Component
System
etc.
Speaker cords
(not supplied)