Filter
Top Products
15
Repeat Playback
Your video recorder can automatically play back the whole tape
20 times repeatedly.
12
45
3
6
8
0
7
9
1
3
2
6
q
PLAY
STOP
REW
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
● The Play indicator ( ) on the display panel blinks
slowly.
● The tape plays 20 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW , FF or PAUSE also stops Repeat Playback.
OPERATE
OPERATE
C. MEMORY
PAUSE
Next Function Memory
You can set your recorder's power to go off automatically after
the tape is fully rewound. Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press OPERATE within 2 seconds.
NOTE:
If you want the power to be turned off automatically when the
counter reads “0:00:00” (instead of at the beginning of the
tape), press C.MEMORY so that the “M” mark appears before
pressing REW.
Tape Position Indicator
The tape position indicator appears
on screen when, from the Stop
mode, you press FF, REW or
perform an Index Search. The
position of “5” in relation to “0”
(beginning) or “+” (end) shows you
where you are on the tape.
”On-Screen” (੬ pg. 22) must be
set to “ON”, or the indicator will
not appear.
NOTE:
Depending on the type of tape used, there may be times when
the indication is not correct.
0
+++
3
1:23:45
REMAIN 2:35
FF
PLAY
STOP