Filter
Top Products
7
English
AM antenna
1
If the cords are covered with insulation, remove
a short section of insulation at the end of each
cord by twisting and pulling it off.
2
Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
3
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other terminals or
connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting cords,
and the AC power cord.
Connecting Speakers
To connect speakers
You can connect the speakers using the speaker cords.
1
If the cords are covered with insulation, remove
a short section of insulation at the end of each
cord by twisting and pulling it off.
2
Hold the clamp of the speaker terminal.
3
Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red cord to red
terminal ª and black cord to black terminal ·.
4
Release your finger from the clamp.
IMPORTANT:
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to one speaker
terminal.
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
Speaker
cord
Speaker
cord
Right speaker Left speaker
RIGHT
LEFT
SPEAKER
IMPEDANCE
4Ω
~
16Ω
SPEAKERS
1
2
3,4
Red
Black
ANTENNA
3
2
1
EN06-08_UX-J55MD[UB]f.p65 7/1/03, 4:29 PM7