JVC GET0622-001A CD Player User Manual


 
1
KD-R416/KD-R415/
KD-R316/KD-R315
Installation/Connection Manual

/
ENGLISH / 
1009DTSMDTJEIN
EN, TH
© 2009 Victor Company of Japan, Limited
GET0623-006A
[U/UH]
Bracket /  *
2
Pocket / 
Flat head screws (M5 × 8 mm) /  (M5 × 8 mm) *
2
INSTALLATION / 
When installing the unit without using the sleeve / 



In-dash mounting / 
 In-dash
• To prevent short circuits:
– Disconnect the battery’s negative terminal and make all electrical connections before installing the unit.
– Cover the terminals of the UNUSED leads with insulating tape.
• Be sure to ground this unit to the car’s chassis again after installation.
• Replace the fuse with one of the specified rating.
• Connect speakers with a maximum power of more than 50 W (impedance of 4 Ω to 8 Ω). Otherwise,
change the <AMP GAIN> setting. (See page 15 of the INSTRUCTIONS.)
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.

:


 
 














  50 W ( 4 Ω  8 Ω) 

 <AMP GAIN> (
15 )
 



12 V DC, NEGATIVE ground /
  12 V, 
 

To the car system /

You need the installation kits which corresponds to your car. /



Check the battery system in your car /


WARNINGS / 
Removing the unit / 

Release the rear section first... / 
...
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
Heat sink /



 



 JVC 

Do the required electrical connections.

 

Bend the appropriate tabs to hold the sleeve firmly
in place.



Install the unit at an angle of
less than 30˚.


 30˚
*
1
*
1
When you stand the unit, be careful not to damage the fuse on the rear.
*
2
Not supplied for this unit.
*
1


 


*
2



Part list / 
A Hard case /  (×1)
B Control panel /
 (×1)
C Sleeve /  (×1)
D Trim plate /  (×1)
E Power cord /  (×1)
F Handles / 
 (×2)
Install_KD-R416_006A_f.indd 1Install_KD-R416_006A_f.indd 1 10/19/09 2:35:35 PM10/19/09 2:35:35 PM