Filter
Top Products
34
If the sound from the audio device connected to
the AUX 1 or AUX 2 jack is too loud or is too quiet
when changing from another source to “AUX,” you
can change the audio input level through the AUX
1 or AUX 2 jack (without changing the volume
level).
Press and hold AUX for 2 seconds
while the AUX is selected as the
source.
Each time you press and hold the button, the audio
input level alternates between AUX LEVEL 1 and
AUX LEVEL 2.
AUX LEVEL 1:
Select this when the sound is too loud with “AUX
LEVEL 2” selected. This setting is recommended
when connecting an audio device other than a
portable audio device to AUX 1 jack.
AUX LEVEL 2:
Select this when listening to a portable audio
device.
Without setting the built-in clock, you cannot use
any timers.
• To exit from the clock setting, press CLOCK/
TIMER as required.
• To correct a misentry during the procedure
below, pressing CANCEL can return to the
previous step.
1 Press CLOCK/TIMER.
• If you have already adjusted the clock
before, press the button repeatedly until the
clock time starts flashing.
2 Press cursor 2/3 to adjust the
hour, then press SET/QP LINK.
3 Press cursor 2/3 to adjust the
minute, then press SET/QP
LINK.
Now the built-in clock starts to work.
Adjusting the audio
input level
Setting the built-in clock
SVCDVD-A
Setting the Various Timer
EX-D11[U].book Page 34 Tuesday, May 30, 2006 4:13 PM