Filter
Top Products
Page 5
To connect the AC power cord of the
main unit
The AC power cord is supplied separately and must be connected to
the unit.
Plug the AC power cord into the AC POWER CORD inlet of this unit and
connect to the wall outlet after all connections are complete.
Note
When using the COMPU LINK Remote Control System, do not connect
the power cord to the SWITCHED AC OUTLET of an amplifier or
receiver.
Supplying the power
To install the batteries in the remote
control unit (for XL-FZ258BK)
Before operating the remote control unit, install two batteries.
1. Remove the rear cover of the remote control unit by pressing
down and simultaneously pulling it backwards.
2. Install batteries. Be sure that the batteries are installed with
correct polarity, (+) and (–).
3. Attach the rear cover by sliding it back into position.
Notes
Incorrect use of batteries can cause corrosion or damage. Note the
following points to lengthen battery life.
÷
Install batteries observing the correct polarity, (+) and (–).
÷
Do not use new and old batteries simultaneously.
÷
Batteries with similar shapes may have different voltage ratings. Be
sure to use the correct batteries.
÷
Remove batteries from the remote control unit if it will not be used
for a long period of time.
÷
Do not expose batteries to heat or flame.
Battery replacement
Service life of batteries depends on the condition of use; standard life
is about one year. When the batteries become weak, the operating
distance of the remote control unit becomes short . If this happens,
replace the batteries R6P(SUM-3)/AA(15F) with new ones.
Note
÷
The lower the temperature, the shorter the battery life.
AC POWER CORD inlet
Rear panel of this unit
Supplied AC power cord
To the wall outlet
·
ª
ª
·
RIGHT LEFT
OUTPUT (SYNCHRO)
COMPU LINK - 3
AC IN
DIGITAL OUT
OPTICAL