JVC MX-KC50 Stereo System User Manual


 
22
Using the Timers
When selecting TAPE:
Insert a cassette tape you want to play into Deck A.
When selecting AUX:
Prepare the external equipment so that it will turn on at the ON
time set by the System.
To allow this, the equipment should have the timer function.
5
Setting the volume level.
Press the ¢ or 4 button to select the volume level.
MIN, 1-30, or MAX: When the timer is turned on, the Volume
will be automatically set to the selected level.
6
Press the SET button.
The timer setting is completed and the display returns to the
display before you set the Timer.
7
Press the STANDBY/ON button to turn
off the System, if necessary.
The Timer indicator ( ) and “DAILY” indicator are lit on the
display, showing that the Daily Timer is set to on.
To confirm / change the timer setting, repeat the setting pro-
cedure from the beginning.
When the timer ON-time comes:
The following operation will be automatically repeated every day.
When the timer ON-time comes, the System automatically
turns on. The music source you have set is played. The Timer
indicator ( ) blinks and “DAILY” indicator lights during
timer operation.
When the timer OFF-time comes, the System automatically
turns off. Then, the Timer indicator ( ) and “DAILY” indica-
tor remain lit on the display.
If the System is already on when the timer ON-time
comes, the Daily Timer does not work.
To cancel the Daily Timer temporarily:
1
Press the CLOCK/TIMER button on the Unit
repeatedly until the “DAILY” appears on the
display.
2
Press the CANCEL button on the Unit.
“OFF” appears and both the Timer indicator ( ) and the
“DAILY” indicator go out.
To activate the cancelled Daily Timer:
1
Press the CLOCK/TIMER button on the Unit
repeatedly until the “DAILY” appears on the
display.
The “DAILY” indicator blinks and the Timer indicator ( )
lights up on the dispaly.
2
Press the SET button on the Unit.
“DAILY SET” appears on the display. The Timer indicator
( ) and the “DAILY” indicator remain lit, and the display re-
turns to the original display.
If the System is unplugged, or a power failure occurs,
the timer setting will be lost in a few days. You will
need to reset the clock first, then the timer.
Setting the REC (Recording)
Timer
With the Recording Timer, you can make a tape of a radio broad-
cast automatically whether or not you are home.
Once you have set the REC Timer to record a source, the timer set-
ting is stored in memory. So, though the REC Timer turns off once
it is used, you can recall it at any time.
You can set the REC Timer whether the System is on or
off.
Perform each setting within approx. 30 seconds. Other-
wise, setting will be cleared and the procedure must be
repeated from the beginning.
If you have made a mistake while setting the timer, press
the CANCEL button on the Unit. However, this does not al-
ways cancel the current setting. If the CANCEL button
does not work, press the CLOCK/TIMER button on the
Unit repeatedly until the display returns to the original dis-
play, and start from the first step.