Filter
Top Products
– 8 –
English
By using audio cords (not supplied), connect:
• Between the audio input jacks on the other equipment and
AUX OUT jacks: For recording on the other equipment.
• Between the audio output jacks on the other equipment and
AUX IN jacks: For playing the other equipment.
To listen to this source, press AUX.
To connect audio equipment with an optical digital
input terminal
You can record CD sound onto the connected digital
equipment.
Audio/video
equipment
Connecting Other Equipment
You can connect both analog and digital equipment.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
To audio output
To audio input
To optical
digital input
Before connecting
the other equipment,
remove the
protective plug from
the terminal.
Audio equipment
with an optical digital
input
Protective
plug
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and the
CD OPTICAL DIGITAL OUTPUT terminal.
Auxiliary Equipment
To connect a TV set
You can connect a TV with a video input jack: used as a
monitor for video CD playback.
VOLTAGE
SELECTOR
110V
220V
127V
230V
-240V
MAIN SPEAKERS
RIGHT
LEFT
ANTENNA
COAXIAL
FM 75
VIDEO
OUT
CAUTION:
SPEAKER IMPEDANCE
6 ~ 16
AM EXT
AM LOOP
SUB WOOFER
RIGHT
LEFT
CAUTION:
SPEAKER IMPEDANCE
6 ~ 16
AUX
RIGHT
LEFT
IN
OUT
CD OPTICAL
DIGITAL
OUTPUT
VIDEO
OUT
To start the display demonstration manually
Press and hold DEMO for more than 2
seconds.
To stop the demonstration, press any button.
NOW, you can plug in the unit and other
connected equipment FINALLY!
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
• If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
To stop the display demonstration, press any button on the
unit or on the remote control.
Voltage mark
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
voltage where you are plugging in the unit.
• DO NOT plug in before setting the voltage
selector on the rear of the unit and all connection
procedures are complete.
VOLTAGE
SELECTOR
110V
220V
127V
230V
-240V
To video input
TV
EN01-12.MX-J970[U] 16/06/2000, 11:17 AM8