JVC CA-MXJ200 Speaker System User Manual


 
– 9 –
English
CAUTION:
SPEAKER IMPEDANCE
6~16 OHMS.
SPEAKERS
RIGHT
LEFT
231
AM (MW/LW) antenna
Connecting Speakers
You can connect a pair of the front speakers.
Right
speaker
Left
speaker
Black
Red
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
Speaker
cord
Speaker
cord
1 Connect the AM (MW/LW) loop antenna to
the AM LOOP terminals as illustrated.
2 Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. (The AM
(MW/LW) loop antenna must remain connected.)
For better reception of both FM and AM (MW/LW)
Make sure the antenna conductors do not touch any other
terminals and connecting cords.
Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Vinyl-covered wire
(not supplied)
AM (MW/LW) loop
antenna (supplied)
231
ANTENNA
AM LOOP
FM 75
COAXIAL
GND
AM
EXT
CA-MXJ300/J200[E] 01-14EN/f 00.4.7, 5:51 PM9