Filter
Top Products
– 11 –
English
Listening to FM and AM (MW/LW) Broadcasts
Tuning in a Station
1
Press FM/AM.
The unit automatically turns on and tunes in
the previously tuned station (FM, MW, or
LW).
• Each time you press the button, the band changes
among FM, MW, and LW.
2
Select a station.
On the unit:
Press and hold TUNING –
or TUNING + for more
than 1 second.
On the remote control:
1) Press TUNING MODE so that
“MANUAL” appears on the
display.
2) Press and hold 4¥1 or
¢¥¡ for more than 1
second.
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
If a program is broadcast in stereo, the ST (stereo)
indicator lights up.
To stop during searching, press TUNING – or TUNING +
or (4¥1 or ¢¥¡ on the remote control).
When you press TUNING – or TUNING + (4¥1
or ¢¥¡ on the remote control) briefly and
repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE on the remote control so
that the MONO indicator lights up on the display.
Reception improves.
To restore the stereo effect, press FM MODE
again so that the MONO indicator goes off.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.
The FM reception mode is restored even when the unit is
turned off.
Presetting Stations
You can preset 30 FM, 8 MW, and 7 LW stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1
Tune in the station you want to preset.
• See “Tuning in a Station” to the left.
2
Press PROGRAM/SET.
The PRGM flashes on the display.
3
Press PRESET – or + to
select a preset number.
4
Press PROGRAM/SET again.
The tuned station in step 1 is stored in the
preset number selected in step 3.
• Storing a new station on a used number
erases the previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning in a Preset Station
1
Press FM/AM.
The unit automatically turns on and tunes in
the previously tuned station (FM, MW, or
LW).
• Each time you press the button, the band changes
among FM, MW, and LW.
2
Select a preset number.
On the unit:
Press PRESET – or +.
On the remote control:
1) Press TUNING MODE so
that “PRESET” appears on
the display.
2) Press 4¥1 or
¢¥¡.
FM/AM
PROGRAM/SET
FM/AM
MHz
PRGM
PRGM
PRESET +–
PRESET +–
FM MODE
PROGRAM/SET
TUNING +
-
TUNING
TUNING MODE
TUNING MODE
EN01-11.CA-MXJ100[E]/f 00.5.10, 0:39 PM11