– 9 –
English
Common Operations
Turning On or Off the Power
To turn on the unit, press
STANDBY/ON so that the STANDBY
lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
STANDBY lamp lights up.
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “– – : – –” soon, while the tuner preset stations
(see page 12) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start
flashing on the display.
2
Press 4 or ¢ to adjust the
hour, then press SET.
• If you want to correct the hour after pressing SET,
press CANCEL. The hour digits start flashing
again.
DAILY
Canceled
ON TIME
ON TIME
CLOCK
REC
3
Press 4 or ¢ to adjust the
minute, then press SET.
To check the clock time
Press DISPLAY while playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until “CLOCK” is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
If there is a power failure
The clock loses the setting and is reset to “– – : – –.” You need to set
the clock again.
STANDBY/ON
STANDBY
STANDBY/ON
STANDBY
PRESET
SET
DISPLAY
CLOCK
/
TIMER
PRESET
SET
EN01-12.CA-MXG50[UW]_f 01.4.3, 2:17 PM9