JVC CA-FSS57 Stereo System User Manual


 
20
Using the Timers
DAILY
On the remote control ONLY:
1
Press CLOCK/TIMER.
The (timer) indicator lights up and the timer
mode indicator (DAILY) flashes on the display.
The unit enters the on-time setting mode.
2
Set the on-time you want the unit to
turn on.
1) Press UP or DOWN to set the hour,
then press CLOCK/TIMER.
2) Press UP or DOWN to set the
minute, then press CLOCK/TIMER.
The unit enters the off-time setting mode.
3
Set the off-time you want the unit
to turn off.
1) Press UP or DOWN to set the hour,
then press CLOCK/TIMER.
2) Press UP or DOWN to set the
minute, then press CLOCK/TIMER.
The unit enters the source setting mode.
Two timers are available—Daily Timer and Sleep Timer.
Before using these timers, make sure the built-in clock is
set correctly (see page 9).
Using the Daily Timer
You can set the timer when the unit is either turned on or in
standby mode.
How the timer actually works
When the on-time comes, the unit automatically turns on (the
(timer) indicator flashes just before the on-time and
continues flashing while the timer is operating). Then, when
the off-time comes, the unit automatically turns off (standby).
The timer setting remains in memory until you change it.
•When the DAILY indicator is lit on the display, the timer
acts as the Daily Timer. Once the timer has been set, it will
be activated at the same time everyday until the timer is
turned off.
Before you start...
When using “TUNER” as the source to play, make sure to
select the desired station before turning off the power.
•There is a time limit in doing the following steps. If the
setting is canceled before you finish, start again from step
1
.
CLOCK/
TIMER
DAILY
Ex.: When the Daily Timer has been selected
the last time.
CLOCK/
TIMER
DAILY
CLOCK/
TIMER
Continued
UP
DOWN
UP
DOWN
20_22_FS_S57[J]_2.p65 04.2.16, 10:01 PM20