JVC CA-FSS57 Stereo System User Manual


 
13
Tuning in to a Station
1
Press FM/AM to select either “FM”
or “AM.”
The unit automatically turns on and tunes in to
the previously received station—either FM or
AM.
Each time you press the button, the band alternates
between FM and AM.
2
Press and hold ¢ or 4
(or ¢ UP or 4 DOWN
on the unit) for more than
1 second.
¢ (¢ UP):
Increases the frequencies.
4 (4 DOWN):
Decreases the frequencies.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
If an FM program is broadcast in stereo, the STEREO
indicator lights up on the display (only when the
reception is good).
To stop during searching, press ¢ or 4 (or ¢ UP or
4 DOWN on the unit).
When you repeatedly press ¢ or 4 (or ¢ UP or
4 DOWN on the unit)
The frequency changes step by step.
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive
or noisy, press FM MODE so that the MONO
indicator lights up on the display. Reception will
improve.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off. In stereo mode, you can hear
stereo sound when a stereo program is broadcast.
Presetting Stations
You can preset 30 FM and 15 AM stations manually.
In some cases, test frequencies have been already stored
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You
can preset the stations you want into memory by following
the presetting method.
•There is a time limit in doing the following steps. If the
setting is canceled before you finish, start again from step
2
.
On the remote control ONLY:
1
Tune in to the station you want to preset.
See “Tuning in to a Station.”
2
Press SET.
“SET” starts flashing on the display.
3
Press UP or DOWN to select a
preset number.
You can also select the preset number
using the number buttons.
Ex.: For preset number 5, press 5.
For preset number 15, press +10,
then 5.
For preset number 20, press +10,
then 10.
For preset number 30, press +10,
+10, then 10.
Listening to FM and AM Broadcasts
FM/AM
FM
MODE
SET
132
465
798
10 +10
UP
DOWN
13_14_FS_S57[J]_2.p65 04.2.16, 10:00 PM13