Filter
Top Products
21
English
IMPORTANT:
• It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
• The recording level is automatically set correctly, so it is
not affected by the other sound settings. Thus, during
recording you can adjust the sound you are actually
listening to without affecting the recording level.
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance
between the TV and the unit.
• You can only use type I tape for recording.
DO NOT use type II and type IV tapes since the
unit is not compatible with such tapes.
The use of C-120 or longer tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.
At the start and end of cassette tapes
There is leader tape which cannot be recorded onto. Thus, when
recording from discs, FM/AM broadcasts, or external equipment,
wind the leader tape first to ensure that the recording will be made
without losing any music.
To protect your recordings
Cassettes have two small tabs on the back to protect against
unexpected erasure or re-recording.
To protect your recording, remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
Recording
Adhesive tape
Recording on a Tape
1
Insert a recordable cassette into the cassette
compartment with the exposed part of the
tape facing left.
• See also page 20.
2
Check the recording direction for the tape.
• If the tape direction is not correct, press 2 3 TAPE
twice then 7 to change the tape direction.
• If you want to record on both sides of a tape, see “To
record on both sides—Reverse Mode” below.
3
Start playing the source—FM, AM or
auxiliary equipment connected to AUX/DVD
jacks.
• When recording from discs, see “Recording Discs—
Disc Synchronized Recording” on page 22.
4
Press REC (recording).
The
REC
(recording) indicator lights up on
the display and recording starts.
“NO REC” will appear on the display when you press
REC in the following cases:
• If no cassette is inserted.
• If a protected tape is inserted.
• If any tray is open when the source is the CD player.
To stop while recording, press 7.
To remove the cassette, press 0 on the unit.
To record on both sides—Reverse Mode
On the remote control ONLY:
Press REV.MODE (reverse mode)
repeatedly so that the Reverse Mode
indicator lights up like— or .
• The Reverse Mode indicator lights up on the
display like— while recording.
• Make sure that the tape direction is set to the forward (3)
direction before starting to record. Otherwise, recording
will stop when only one side (reverse) of the tape is
recorded.
To cancel the Reverse Mode, press the button so that the
Reverse Mode indicator lights up like— .
REC
TAPE
REV.
MODE
21_24FS_B70[C].p65 03.3.19, 2:30 PM21