Filter
Top Products
English
– 8 –
For playing the other equipment through this unit, connect
between the audio output jacks on the other equipment and
AUX jacks by using audio cords (not supplied).
To listen to this source, press AUX.
To connect audio equipment with an optical digital
input terminal
You can record CD sound onto the connected digital
equipment.
To audio output
Connecting Other Equipment
You can connect both analog and digital equipment.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
Audio/video
equipment
VOLTAGE
SELECTOR
110V
127V
127V
230V
-240V
MAIN SPEAKERS
RIGHT
LEFT
ANTENNA
COAXIAL
FM 75
VIDEO
OUT
CAUTION:
SPEAKER IMPEDANCE
6 ~ 16
WARNING: SHOCK HAZAD-DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
AM EXT
AM LOOP
AUX
RIGHT
LEFT
SUB WOOFER
RIGHT
LEFT
CAUTION:
SPEAKER IMPEDANCE
6 ~ 16
VICTOR COMPANY OF JAPAN, LIMITED
GV10026-016A
VIDEO
OUT
CD OPTICAL
DIGITAL
OUTPUT
Auxiliary Equipment
To video input
TV
Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
voltage where you are plugging in the unit.
• DO NOT plug in before setting the voltage
selector on the rear of the unit and all connection
procedures are complete.
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Protective
plug
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and the
CD OPTICAL DIGITAL OUTPUT terminal.
To connect a TV set
You can connect a TV with a video input jack: used as a
monitor for video CD playback.
NOW, you can plug in the unit and other connected
equipment FINALLY!
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
• If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor (except for Argentine).
To stop the display demonstration, press any button on the
unit or on the remote control.
VOLTAGE
SELECTOR
110V
220V
127V
230V
-240V
To optical
digital input
Before connecting
the other equipment,
remove the
protective plug from
the terminal.
Audio equipment
with an optical digital
input
Voltage mark
To start the display demonstration manually
Press and hold DEMO for more than 2 seconds.
To stop the demonstration, press any button.
EN01-12.MX-J770[U]/3 16/06/2000, 9:24 AM8