Filter
Top Products
9
English
Common Operations
Turning On or Off the Power
To turn on the unit, press STANDBY/ON
so that the STANDBY lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
STANDBY lamp lights up.
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “– – : – –” soon, while the tuner preset stations
(see page 12) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Turn the 4/¢ control to adjust
the hour, then press SET.
The minute digits start flashing on the
display.
• If you want to correct the hour after pressing SET,
press CANCEL/DEMO. The hour digits start
flashing again.
3
Turn the 4/¢ control to
adjust the minute, then press SET.
To check the clock time
Press DISPLAY while playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until “CLOCK” is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
If there is a power failure
The clock loses the setting and is reset to “– – : – –.” You need to set
the clock again.
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
• This function works only when the unit is turned off.
• 10 kHz spacing is the initial setting.
On the unit ONLY:
To select 9 kHz, press REPEAT while holding down 1
(TUNING –) when the unit is in standby mode.
“AM - 9” appears on the display.
To select 10 kHz interval again, press REPEAT while
holding down ¡ (TUNING +) when the unit is in standby
mode.
“AM - 10” appears on the display.
STANDBY
STANDBY/ON
ON TIME
(Daily Timer)
DAILY
Canceled
ON TIME
(Recording Timer)
CLOCK
REC
STANDBY
STANDBY/ON
CLOCK
/ TIMER
DISPLAY
SET
SET
REPEAT
TUNING
REPEAT
TUNING
+
+
EN09_10MXGA77[UW].pm6 03.5.8, 8:04 AM9