Filter
Top Products
8
English
Connecting Other Equipment
You can connect audio equipment—used only as a playback
device.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect audio equipment
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX IN jacks by using audio cords (not
supplied).
To audio output
AUX IN
Audio equipment
CANCEL
/ DEMO
CANCEL
/ DEMO
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
voltage where you are plugging in the unit. (See the back
cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection
procedures are complete.
NOW you are ready to plug in the unit and
other connected equipment.
• If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
Canceling the Display Demonstration
When connecting the AC power cord into a wall outlet, the
unit automatically starts the display demonstration.
On the unit ONLY:
To cancel the display demonstration,
press CANCEL/DEMO while the display
demonstration is shown on the display.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) until you
cancel it.
To start the display demonstration manually
Press and hold CANCEL/DEMO again for
more than 2 seconds.
ANTENNA
FM 75
AM
[ ]
VOLTAGE
SETTING
220
127
240
110
230
AUX IN
MAIN SPEAKER
SUBWOOFER
[ ]
RR
LL
[ ]
4-8
6-16
VOLTAGE
SETTING
-
220
127
240
110
230
-
EN01_08MXGA77[UW].pm6 03.5.8, 8:04 AM8