Filter
Top Products
25 CA-EX90
From the remote control
1 Press TUNER to select the band you desire
(FM or AM).
In addition to selecting the FM band, this operation also
sets the remote control to tuner operation mode. The
remote control must be set to the tuner operation mode
before proceeding to the following steps, even if the
band was previously set to FM using the controls on the
front panel.
2 Tune in the station you desire.
For manual tuning
Press /\ (£) (for higher frequencies) or \/ (7) (for lower
frequencies) repeatedly to locate the frequency of the
station you desire. When a station is received, the
TUNED indicator lights up.
For automatic tuning
Hold down /\ (£) or \/ (7) until the frequencies start to
change, then release. When a station is tuned in, the
TUNED indicator lights up and the frequency stops
changing. If you know the frequency of the station you
want to receive, keep holding /\ (£) or \/ (7) until the
amplifier/tuner nears the frequency you desire (this
prevents the amplifier/tuner from stopping at other
intermediate stations).
Stereo and monaural reception
Switching to monaural reception is an effective way to reduce noise when receiving weak FM stereo
broadcast.
To switch to monaural reception
Press FM MODE/MUTING on the remote control so that
“MONO” appears in the display. This switches the
reception mode to mono. In this mode, stereo broadcasts
are also received in mono.
To switch to stereo reception
Press FM MODE/MUTING on the remote control again so
that “AUTO” appears in the display. This switches the
reception mode to auto tuning. When a program is
broadcast in stereo the STEREO indicator lights up and you
hear the stereo sound. When in monaural, the STEREO
indicator goes off and you hear monaural sound.
Normally, it is recommended to use Automatic tuning. If clear reception is not possible
with the supplied antenna, connect an external antenna (see page 14).
TUNER
FM MODE
/MUTING
EN24-27.CA-EX90[J]/1 98.6.8, 8:24 AM25