Filter
Top Products
10. Attach the frame to the bracket by
screwing the frame to the bracket using
the supplied screws.
NOTE: Do not over
tighten the screws, this will distort the
frame and the grille will not fit
.
11. The screws should pull the frame and
bracket together (sandwiching the
drywall) so that the frame is flush with
the wall surface.
12. Strip 1/4” of insulation from the end of
each wire.
13. Tightly twist the end of each wire until
no frayed ends remain.
14. Attach the speaker wires to the speaker
terminal connectors. Connect the
negative output from the amplifier to the
black terminal. Connect the positive
output from the amplifier to the red
terminal.
15. Insert the speaker into the frame and
snap it into place. See figure 2.
16. Optional: If you are located in an
earthquake zone or want the added
security of screwing the speaker baffle
to the frame, follow the Important Safety
Instructions on page 5.
17. Repeat steps 1-16 for each speaker
being installed.
18. After making tonal adjustments on all
speakers (LSW-6.5 only), install the grille
into the speaker.
Installation New Construction:
The speaker brackets should be installed
prior to the drywall.
1. Attach the wings to the bracket by
snapping them into the sides of the
bracket. (See Figure 1). To shorten the
wings, break them along the scored lines.
2. The wings and brackets have centering
lines to simplify placement of the speaker.
3. Use a tape measure to locate and center
the brackets in the wall.
4. Mark each speaker location with a
pencil.
5. Screw one side of the assembled bracket
with wings to the joist using one of the
supplied screws.
6. Screw the other side of the bracket/wing
assembly to the joist. Two screws on
each side make for a very secure
installation.
7.
Secure the wire to the bracket using the
bracket’s wire tie.
Figure 3
Break away two of the outer
mounting tabs on the side
you wish to affix.
Emergency
screw hole
for butting
bracket
against
joist.
3
Figure 2
DS00387ACN_LSW-6_6.5.qxp 11/18/04 6:55 PM Page 3