Filter
Top Products
3
2. (Auto) POWER Switch: Use the ALWAYS ON mode to leave the LSS-10 and LSS-12 always
on. Use the MUSIC/VOLTAGE SENSE mode to automatically power on the LSS-10 and
LSS-12 when audio signals are present or when system trigger is used. When signals are
absent, the LSS-10 and LSS-12 will enter the standby mode.
NOTE: The ALWAYS ON and MUSIC/VOLTAGE SENSE settings are only active after (Master)
POWER is set to ON (see below).
3. AUDIO IN jacks: Use these gold-plated, line-level RCA input jacks to connect line-level
stereo or LFE audio signals from a home theater surround sound processor or receiver.
The LFE (Low Frequency Effects) input is not affected by the LOW PASS Frequency
Control. The PHASE Control and LEVEL Control continue to function as normally expected.
4. AUDIO OUT jacks: Use these gold-plated, line-level RCA output jacks to connect
line-level stereo or LFE audio signals to drive another LSS-10 or LSS-12 or loop your line
level audio signal back to your surround sound processor or receiver. (The L/R output
signals are routed through a fixed HIGH-PASS (80 Hz) filter).
5. SPEAKER IN Binding Posts: As an alternative to the AUDIO IN jacks, use the loudspeaker-
level, gold-plated, five-way binding posts to connect loudspeaker-level, stereo audio
signals from a home theater surround sound processor or receiver. For additional
connection details, see Finishing the Installation on page 5.
6. SPEAKER OUT Binding Posts: As an alternative to the AUDIO OUT jacks, use the
loudspeaker-level, gold-plated, five-way binding posts to connect loudspeaker-level,
stereo audio signals to drive your front L/R satellite loudspeakers.
7. (Master) POWER Switch: Use this control to power on/off the LSS-10 and LSS-12.
8. Detachable IEC Power Cord and built-in fuse. If needed, replace the fuse with same type,
as follows:
■ For 115/120 Vac @ 60 Hz, use a T5AL, 250V fast-blow fuse.
■ For 230/240 Vac @ 50 Hz, use a T3.15AL, 250V fast-blow fuse.
DS00490ACN-0 LSS-10_12.indd 3 5/23/06 2:12:58 PM