Filter
Top Products
6
LINE OUT OPERATION
FOR BETTER PLAYBACK SOUND, YOU CAN CONNECT THE SB6051 TO AN EXTERNAL AUDIO
AMPLIFIER VIA THE RCA LINE OUT JACKS LOCATED ON THE BACK PANEL. PLEASE PROCEED AS
FOLLOWING:
1. CONNECT THE “L” & “R” LINE OUT JACKS AND THE AUX IN OF YOUR AUDIO AMPLIFIER.
(CONNECTION CABLE IS NOT INCLUDED).
2. SELECT THE MUSIC SOURCE BY SETTING THE FUNCTION SELECTOR (5) TO “PHONO”, “AM”,
“FM” OR “FM ST” AS DESIRED.
3. TURN ON THE EXTERNAL AMPLIFIER.
4. SOUND WILL THEN COME OUT FROM THE SYSTEM’S BUILT-IN SPEAKERS AND THE
EXTERNAL AMPLIFIER’S SPEAKERS SIMULTANEOUSLY.
5. SET THE VOLUME CONTROL (8) TO “MIN” AND ADJUST THE SOUND LEVEL USING THE
VOLUME CONTROL ON THE EXTERNAL AMPLIFIER AS DESIRED.
6. TURN THE SYSTEM AND THE EXTERNAL AMPLIFIER OFF WHEN YOU HAVE FINISHED
LISTENING.
7. UNPLUG THE CONNECTION CABLE.
CARE AND MAINTENANCE
CLEAN YOUR UNIT WITH A DAMP (NEVER WET) CLOTH. SOLVENT OR DETERGENT SHOULD
NEVER BE USED.
1. AVOID LEAVING YOUR UNIT IN DIRECT SUNLIGHT OR IN HOT, HUMID OR DUSTY PLACES.
2. KEEP YOUR UNIT AWAY FROM HEATING APPLIANCES AND SOURCES OF ELECTRICAL
NOISE SUCH AS FLUORESCENT LAMPS OR MOTORS.
3. ALWAYS CLEAN THE OUTSIDE OF THE CABINET THOROUGHLY IF IT BECOMES WET WITH
MOISTURE OR WATER SPLASHES. THIS WILL HELP TO PROTECT THE INTERNAL PARTS OF
THE UNIT FROM ENTRY OF WATER AND POSSIBLE MOISTURE DAMAGE.
STYLUS REPLACEMENT
PLEASE REFER TO THE DIAGRAM BELOW TO REPLACE THE STYLUS.
NO ADDITIONAL STYLUS IS SUPPLIED WITH THE SYSTEM.
(1) Loosen the red part of stylus
by screw driver and take out
as dia
g
ram A and B
(2) Replace with the new stylus
(not included) as diagram C
and D