Filter
Top Products
7
QUICK SETUP GUIDE
way before plugging in your audio source. Turn CH1 and/or
CH2 Encoders to the left until the level reads “- 100” on
the LCD.
2. Connect XLR or TRS cable from audio source to CH1 and/or
CH2 Inputs.
3. Select LINE, CONSUMER or MIC gain setting by pushing the
correct CHANNEL ENCODER twice. You will see a rectangle
highlighting the sensitivity setting. Simply roll the encoder
left or right to select the correct setting. Once the correct
setting is shown, push the encoder one more time to make
your selection.
Set output levels
1. Set the gain level for each input using the CH1 and/or CH2
ENCODER. The input level meter on the LCD will allow you to
monitor your input level.
2. Once the input level is set, user the MASTER ENCODER to
turn up (Right) or turn down (Left) the overall level until the
desired volume is reached.
Power it on
1. Connect the supplied power cord to the Blue IEC inlet on
the rear of the speaker
2. Connect the power cord to an available power outlet.
Once the power cord is plugged into the power source,
the Green Power LED will illuminate.
3. Once the Green Power LED illuminates, press the Power
Button. After several seconds, you will notice the LCD
Screen boot and you will now be on the main screen.
Plug in the inputs
1. The CH1 and CH2 Input levels and Master Level default
to -20dB. It’s a good idea to turn the inputs down all the
OUTIN
CH
2
CH
1
OUT
MIX OUT
NETWORK
LINK
MASTER LEVEL
BACK
POWER
DATA
IN
A HARMAN INTERNATIONAL COMPANY
DESIGNED AND ENGINEERED IN THE USA
MADE IN MEXICO
SERIAL NO. JBL PROFESSIONAL NORTHRIDGE, CA USA
MAIN MENU
PRESET
AUTO DIM
AUTO SLEEP
METERS
2 MAIN
OFF
ON
Power Button
CH1 Direct Out
CH2 Direct Out
CH1 Input
CH2 Input
CH1 Encoder
CH2 Encoder
Locking IEC Inlet
Power LED
LCD Screen
Master Encoder
Back Button
Mix Out
Ethercon Connector
Data LED
Link LED