Filter
Top Products
31
SRX800 Speakers can be used in Audio Architect version 1.60 and later. Audio Architect can be used to control all DSP parameters
of SRX800. Some functions, such as building and saving DSP presets in the speakers themselves, are only available through
Audio Architect. To download Audio Architect, visit http://www.jblpro.com/www/products/portable-market/srx800-series and select
the latest version of Audio Architect.
See the networking section above for instructions on connecting speakers to a network.
Some users will not see every speaker on the network the first time they connect new speakers. The most probable cause for this is
that two or more speakers are automatically set to the same HiQnet address when they are brand new. Each speaker must have its
own unique HiQnet address in order for the system to recognize them. If you aren’t seeing connected speakers on your network, you
can use HiQnet NetSetter to reset the HiQnet addresses of speakers on the system. NetSetter can be downloaded at
http://www.jblpro.com/www/products/portable-market/srx800-series.
NETWORKING
Once your speakers are networked, they will show up in
the left hand panel on audio architect. A full list of Audio
Architect compatible Harman devices is also available for
creating shows while offline.
Double-click the speaker to bring up its control panel.
Drag speakers from the left hand panel into the room to start
working with them.
More in-depth instructions on using SRX with Audio Architect can be found at http://www.jblpro.com/www/products/portable-
market/srx800-series
Double-click any of the DSP parameters to adjust those.