Filter
Top Products
10
Connections (cont.)
Headphones
Connecting a headphone automatically dis-
ables the loudspeakers in order to provide a pri-
vate listening session.
Antenna
Important
FM Antenna Connection
Unless radio signals are very weak, no external
antenna is necessary. Simply connect the sup-
plied FM indoor antenna wire to the terminal
marked FM on the back of the unit .
AM Antenna Connection
Connect the supplied AM loop antenna to the
terminal marked AM on the back of the unit .
Position
it for the
best
reception
FM indoor
antenna
75 ohms coaxial cable
FM external
antenna
(not supplied)
AM
AM loop antenna
(included)
FM
GND
44
44
32
GETTING STARTED
Setting the clock will be demonstrated with the
example of 9:25 AM.
Although JBL Soundgear will retain the clock
setting when you power it down into the
Standby mode, the setting will be lost if the
unit is unplugged or the electrical power is
interrupted for more than 10 seconds. In that
event, the clock setting will be erased, and JBL
Soundgear will display a blinking “— : —“.
When setting the time, remember that midnight
is at 12:00 AM and noon is at 12:00 PM.
1. Press the Clock button ™. (If the clock was
previously set, press and hold the Clock button
for more than 1.5 seconds.)
“12:00 AM” will blink in the Display c, to
indicate civilian 12-hour time. Press the Preset
Up c or Preset Down g button to display a
blinking “0:00”, which denotes 24-hour military
time.
2. Choose between the 24-hour display or 12-
hour display by pressing the Preset Up c or
the Preset Down g buttons.
3. Press the Set/Station button ∞ to store this
setting and proceed to the next step.
4. Set the hour by pressing the Preset Up c
or the Preset Down g buttons.
5. Press the Set/Station button ∞.
6. Set the minute by pressing the Preset Up
c or the Preset Down g buttons.
7. Press the Set/Station button ∞, and the
clock will resume normal operation.
Setting the Clock