Filter
Top Products
6
Connect each speaker to
the corresponding speaker
terminals on your receiver
or amplifier.
If you are using a subwoofer,
follow the directions in that
owner’s guide to connect
and configure it.
Configure your receiver or
processor to reflect the
correct number of speakers
in your system. If you have
added one SCSSAT500/300/200
speaker to a 5.1-channel
system, reconfigure it as a
6.1 system. If you have added
two SCSSAT500/300/200
speakers to a 5.1-channel
system, reconfigure it as a
7.1 system.
The SCSSAT500/300/200
should be set to “Small.” If
your receiver allows you to
set the crossover frequency
between the subwoofer and
the speakers, select
100Hz or
the setting that is the closest
frequency below it.
SYSTEM CONNECTION
– +
– +
– +
– +
– +
– +
– +
– +– +
Receiver
Subwoofer
Out
Left
Front
Left
Surround
– +
Right
Front
Right
Surround
Subwoofer
Center
Surround Back
Left
– +
Surround Back
Right
LFE In
Right Surround
Right Front
Left Surround
Left Front
Center
– +
Surround Back
Left
– +
– +
Surround Back
Right
SCS-SAT500,300,200 OM 4/25/07 11:39 AM Page 8