Filter
Top Products
If there is no sound from
any of the speakers:
• Check that receiver/
amplifier is on and that
a source is playing.
• Review proper operation
of your receiver/amplifier.
If the system plays at low
volumes but shuts off as
volume is increased:
• Check all wires and
connections between
receiver/amplifier
and speakers.
• Make sure all wires are
connected. Make sure none
of the speaker wires are
frayed, cut or punctured.
• If more than one pair of
main speakers is being
used, check the minimum
impedance requirements of
your receiver/amplifier.
If there is no sound from
the center speaker:
• Check all wires and
connections between
receiver/amplifier and
speaker. Make sure all wires
are connected, and that
none of the speaker wires
are frayed, cut or punctured.
Make sure no wires are
touching other wires or
terminals and creating a
short circuit.
• If your receiver/processor
is set in Dolby* Pro Logic*
mode, make sure the center
speaker is not in phantom
mode.
• If your receiver/processor
is set in Dolby Digital or
DTS
®
mode, make sure the
receiver/processor is
configured so that the
center speaker is enabled.
TROUBLESHOOTING
We, Harman Consumer International
2, route de Tours
72500 Chateau-du-Loir
France
declare in own responsibility, that the
loudspeaker described in this owner’s manual is
in compliance with technical standards:
EN 50081-1:1992
EN 50082-1:1997
Luc E. Godard
Harman Consumer International
Chateau-du-Loir, France. 7/01