JBL AVA7 Stereo Amplifier User Manual


 
3
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near
water.
6. Clean only with a dry cloth.
7. Do not block any ventilation
openings. Install in accordance
with the manufacturer’s instructions.
8. Do not install near any heat sources
such as radiators, heat registers, stoves
or other apparatus (including amplifiers)
that produce heat.
9. Do not defeat the safety purpose of
the polarized or grounding-type plug. A
polarized plug has two blades with one
wider than the other. A grounding-type
plug has two blades and a third ground
-
ing prong. The wide blade or the third
prong is provided for your safety. If the
provided plug does not fit into your out-
let, consult an electrician for replace-
ment of the obsolete outlet.
10. Protect the power cord from being
walked on or pinched, particularly at
plugs, convenience receptacles and
the point where they exit from the
apparatus.
11. Only use attachments/accessories
specified by the manufacturer.
12. Use only with the cart, stand,
tripod, bracket or table specified by the
manufacturer or sold with the appara-
tus. When a cart is used,
use caution when mov-
ing the cart/apparatus
combination to avoid
injury from tip-over.
1
3.
U
nplug this apparatus during light-
ning storms or when unused for long
periods of time.
14. Refer all servicing to qualified
service personnel. Servicing is required
when the apparatus has been damaged
in any way, such as power-supply cord
o
r plug is damaged, liquid has been
s
pilled or objects have fallen into the
apparatus, the apparatus has been
exposed to rain or moisture, does not
operate normally, or has been dropped.
15. Do not use attachments not recom-
mended by the product manufacturer,
as they may cause hazards.
16. This product should be operated
only from the type of power source indi-
cated on the marking label. If you are
not sure of the type of power supply to
your home, consult your product dealer
or local power company
. For products
intended to operate from battery power,
or other sources, refer to the operating
instructions.
17. If an outside antenna or cable
system is connected to the product,
be sure the antenna or cable system
is grounded so as to provide some
protection against voltage surges
and built-up static charges. Article
810 of the National Electrical Code,
ANSI/NFPA 70, provides information
with regard to proper grounding of the
mast and supporting structure, ground-
ing of the lead-in wire to an antenna
discharge unit, size of grounding con-
ductors, location of antenna-discharge
unit, connection to grounding elec-
trodes, and requirements for the
grounding electrode. See Figure A.
1
8.
A
n outside antenna system should
not be located in the vicinity of over-
head power lines or other electric light
or power circuits, or where it can fall
into such power lines or circuits. When
installing an outside antenna system,
extreme care should be taken to keep
f
rom touching such power lines or cir-
c
uits, as contact with them might be
fatal.
19. Do not overload wall outlets, exten-
sion cords, or integral convenience
receptacles, as this can result in a risk
of fire or electric shock.
20. Never push objects of any kind into
this product through openings, as they
may touch dangerous voltage points or
short-out parts that could result in a fire
or electric shock. Never spill liquid of
any kind on the product.
21. The apparatus shall not be exposed
to dripping or splashing, and no objects
filled with liquids, such as vases, shall
be placed on the apparatus.
22. Do not attempt to service this prod-
uct yourself, as opening or removing
covers may expose you to dangerous
voltage or other hazards. Refer all serv-
icing to qualified service personnel.
23. When replacement parts are
required, be sure the service technician
has used replacement parts specified
by the manufacturer or that have the
same characteristics as the original
part. Unauthorized substitutions may
result in fire, electric shock or other
hazards.
24. Upon completion of any service or
repairs to this product, ask the service
technician to perform safety checks to
determine that the product is in proper
operating condition.
25. The product should be mounted to a
wall or ceiling only as recommended by
the manufacturer.
READ FIRST! IMPORTANT SAFETY PRECAUTIONS!
Figure A.
Example of Antenna Grounding as per
National Electrical
Code ANSI/NFP
A 70
HCGUL1492/6500 04/2004 EN
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
l
iterature accompanying the appliance.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: To reduce the risk of electric shock, 
d
o not remove cover (or back). 
No user-serviceable parts inside. 
Refer servicing to qualified service personnel.
C
AUTION: To prevent electric shock,
do not use this (polarized) plug with 
an extension cord, receptacle or other outlet 
u
nless the blades can be fully inserted to 
prevent blade exposure.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
“dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute 
a risk of electric shock to persons.
AVA 7 OM (New) 6/20/05 3:50 PM Page 3