JAMO PRO-OE4BS Satellite Radio User Manual


  Open as PDF
of 6
 
128-5868
3 of 6
3
"Repeat step 4 for each transmitter you wish to program".
NOTE: Any button(s) of the transmitter may be used in place of the lock
symbol button for channel 1, however using the proper symbol
will obviously be less confusing for the consumer.
5) Press and release the valet push-button program switch once to ad-
vance to channel 2. The dash mounted LED will Flash 2 times, indicat-
ing that the unit is ready to accept programming for the disarm/unlock
channel # 2.
6) Press and hold the unlock symbol button of the transmitter you wish to
program for 4 seconds or until a long chirp is heard from the siren, or the
interior/parking lights flash.
"Repeat step 6 for each transmitter you wish to program".
NOTE: Any button(s) of the transmitter may be used in place of the unlock
symbol button for channel 2, however using the proper symbol will
obviously be less confusing for the consumer.
7) Press and release the valet push-button program switch once to ad-
vance to channel 3. The dash mounted LED will Flash 3 times, indicat-
ing that the unit is ready to accept programming for the trunk release/
remote start, channel # 3 output.
8) Press and hold the trunk/key symbol button of the transmitter you wish
to program for 4 seconds or until a long chirp is heard from the siren, or
the interior/parking lights flash.
"Repeat step 8 for each transmitter you wish to program".
NOTE: Any button(s) of the transmitter may be used in place of the trunk
symbol button for channel 3, however using the proper symbol will obvi-
ously be less confusing for the consumer.
9) Press and release the valet push-button program switch once to ad-
vance to channel 4. The dash mounted LED will Flash 4 times, indicat-
ing that the unit is ready to accept programming for optional device
connected to channel # 4.
10) Press and hold the option button of the transmitter you wish to program
for 4 seconds or until a long chirp is heard from the siren, or the interior/
parking lights flash.
"Repeat step 10 for each transmitter you wish to program".
 previous next