Filter
Top Products
128-5868
2 of 6
Some of the more popular options available for the unused Option Button
of your transmitter are:
AS 9554 Remote Garage Door Interface
AS 9153 Remote window roll up
AS 9256 Remote trunk release relay
PROGRAMMING TRANSMITTERS:
NOTE: It is important to remember that during the programming mode,
each individual step must be completed within 15 seconds of the
previous step. If the 15 second time limit expires between steps,
the unit will automatically exit the program mode. This is indi-
cated by a long chirp from the siren.
Non alarm models will flash the parking lights only to confirm the transmit-
ter code has been learned and stored.
Also understand that the lock and the unlock buttons used in combination
after arming are preassigned for the shock sensor defeat function. Do not
attempt to use this combination of buttons for any other purpose.
NOTE: In addition to the LED flash patterns listed below, If you are pro-
gramming the transmitter to an alarm system, the siren will also
chirp. If you are programming to a keyless entry system, the
interior and or parking lights may also flash.
TO PROGRAM ADDITIONAL TRANSMITTERS:
1) Enter the vehicle, and turn the ignition switch to the on position.
2) Press and release the valet push-button program switch 3 times.
3) The dash mounted LED will flash 1x indicating that the system is ready
to accept programming for arm/lock, receiver channel #1.
4) Press and hold the lock symbol button of the transmitter you wish to
program for 4 seconds or until a long chirp is heard from the siren, or
the interior/parking lights turn flash.
2