Filter
Top Products
5
English
3.4 Place the headset in the
charge cradle and charge for a
minimum of 30 min. before
use. A full charge takes about
2 hours. The visual indicator
on the headset will fl ash green
while headset is charging, and
the light will remain steady green
when fully charged. The same
procedure is to be followed when
using the travel charger.
3.5 Turn the headset on by
pressing the Answer/End button
for 1 sec. (the visual indicator will
fl ash blue four times and headset
will beep three times), or by
placing headset in charge cradle.
Turn the headset off by pressing
the Answer/End button for 2 sec.
(visual indicator will fl ash blue
four times and headset will beep
three times).
3.4
3.5
3.8
3.6
Clear dial tone
3.6 Take the headset out of
charge cradle and put it on.
3.7 Pick up the telephone handset
and listen for a dial tone through
the headset.
3.8 If dial tone is missing or unclear,
slowly slide the clear dial tone
switch on bottom of base unit
through the 3 settings.
3.9 Set the switch to the position
that gives the clearest dial tone.
2 sec
3.7
3.9