Filter
Top Products
4
5
5
4
2
3
Turning your headset on and off
• Press
the answer/end button to turn on your headset.
• Press
and hold the answer/end button to turn off your headset.
Pair it with your phone
Before you use your Jabra BT350, you need to pair it with your mobile
phone.
1. Put the headset in pairing mode
•
Make sure the headset is off.
• Press and hold
the answer/end button until a solid blue light comes on.
2. Set your Bluetooth phone to ‘discover’ the Jabra BT350
Follow your phone’s instruction guide. This usually involves going to a
‘setup,’ ‘connect’ or ‘Bluetooth’ menu
on your phone
and selecting the
option to ‘discover’ or ‘add’ a Bluetooth device.*
(See example from a
typical mobile phone in fig.
5)
3. Your phone will find the Jabra BT350
Your phone then asks if you want to pair with it. Accept by pressing ‘Yes’
or ‘OK’ on the phone and confirm with the
passkey or PIN = 0000 (4
zeros).
Your phone will confirm when pairing is complete. In case of unsuccessful
pairing, repeat steps 1 to 3.
Wear it how you like it
The Jabra BT350 is ready to wear on your right ear. If you prefer the left,
gently flip and rotate the earhook 180
°. See fig 3.
For optimal performance, wear the Jabra BT350 and your mobile phone
on the same side of your body or within line of sight. In general, you will
get better performance when there are no obstructions between your
headset and your mobile phone.
How to…
Answer a call
• Tap
the answer/end button on your headset to answer a call.
End a call
• Tap
the answer/end button to end an active call.
Make a call
• When you make a call from your mobile phone, the call will (subject to
phone settings) automatically transfer to your headset. If your phone
does not support this function, tap on the answer/end button on the
Jabra BT350 to receive the call in the headset.
Reject a call*
•
Press the answer/end button when the phone rings to reject an
incoming call. Depending on your phone settings, the person who called
you will either be forwarded to your voice mail or hear a busy signal.
Activate voice dialing*
• Tap
the answer/end button. For best results, record the voice-dialing tag
through your headset. Please consult your phone’s user manual for more
information about using this feature.
Redial last number*
• Press
the answer/end button.
Adjust sound and volume
• Press
the volume up or down (+ or -) to adjust the volume.
•
To mute,
press
both volume up and down at the same time. A low beep
alert plays during a muted call.
•
To un-mute,
tap
either of the volume buttons.
Call waiting and placing a call on hold*
This lets you put a call on hold during a conversation and answer a waiting call.
• Press
the answer/end button once to put the active call on hold and
answer the waiting call.
• Press
the answer/end button to switch between the two calls.
• Tap
the answer/end button to end the active conversation.
Call vibrate*
• Call vibrate is automatically activated when you turn on your headset.
• To disable the call vibrate feature,
press
the answer/end button and
press
the volume down (-) button at the same time.
• To reactivate the call vibrate feature,
press
the answer/end button and
press
the volume up (+) button at the same time.
* Dependent on your phone supporting this function. Please check
your phone’s user manual for further details. Call vibrate feature
does not work with the Jabra A210.