Filter
Top Products
US
INSTALLATION AND SETUP
Step 1: Attach the headset to the headband
Included in the standard package are the headband
neckband and ear hook wearing styles. If you want
to attach the neckband or ear hook, refer to the
procedures in the full user manual on the CD-ROM
supplied with your headset.
1. Align the mounting surface of the headset with
matching socket on the headband attachment.
2. Press the headset assembly firmly onto the outer
side of the headband attachment until it clicks into
place (snap-to-click). If you have trouble pressing
them together, try to rotate the boom arm about
30 and try again.
3. Rotate the headset boom arm for left- or right-ear
use as needed. Always position the microphone so
that it sits as close to the corner of your mouth as
possible when you wear the headset.
4. Adjust the length of the headband to fit snugly
around your head.
Step 2: Adjust the headset cradle
The headset cradle is already attached to the Jabra
PRO base when it is delivered but you might want to
adjust its angle in order to optimize for left- or right-
handed docking.
To do this, simply rotate the cradle until it sits at your
preferred docking angle. As you rotate the cradle, you
will feel it fit into a number of distinct positions on the
base. The figure below shows the angular range; -90
to +45 degrees.
-90
45
Step 3: Apply power to the base
Connect the mains power adapter to the base’s power
port (marked with ), then plug it into a mains
power socket.