Filter
Top Products
If you hear an echo of your voice – You may need to adjust
microphone levels.
To reduce the echo:
Flashes or
Beeps
Microphone Level
1
2
3
High (default)
Medium
Low
1. Lower the volume of your phone and headset.
2. If echo persists, put FreeSpeak in Active mode.
3. Use the stylus to press down on the stylus switch (as shown above) until you see a solid
c blue light on the multi-adapter. Continue to press down until you see/hear 1, 2, or 3
z flashes/beeps, then release. The last number of flashes/beeps corresponds to the final
c setting.
4. Repeat step 3 to cycle between different microphone levels.
TIPS & SOLUTIONS
To prolong battery life:
• After you’ve ended a call using your phone’s keypad, always remember to place the
headset in Standby mode by pressing and releasing when not in use.
• Dock the headset firmly in its multi-adapter when not in use.
If you press and release and the headset stays in Standby mode:
If FreeSpeak becomes unpaired, it will not respond to the button. In rare cases, this may
occur when you first receive the product or when you hold the button too long while using
the product.
To “pair” the headset with the multi-adapter:
1. Ensure headset is off.
2. Press until you see a solid blue light on the headset, then release.
3. Use the stylus to press down on the
stylus switch until you see a solid blue
light on the multi-adapter, then
release.
Important: Once pairing is complete,
lights on both the headset and multi-
adapter will begin flashing (Standby
mode).
Multi-adapter
Stylus
Switch
Stylus