Filter
Top Products
LISTENING TO THE RADIO
Manual Tuning
1. In Tuner mode,Press “ /BAND” button to select the desired BAND (AM or FM).
2. Tune to the desired station by pressing the or button.
3. Adjust volume control to the desired volume level.
Auto Tuning
1. In Tuner mode, press “ /BAND” button to select the desired BAND (AM or FM).
2. Press and hold the or button for 1-2 seconds and then release.
3. The unit will start seeking automatically and stop when the radio station is reached.
4. Repeat steps 2 and 3 until the desired radio station is reached.
5. Adjust the volume control to the desired volume level.
Preset Stations using Remote Handset
You can store up to a total of 20 radio stations in memory.
1. Set to TUNER mode.
2. Turn to the desired radio station by “MANUAL” or “AUTO” tuning method.
3. Press “PROG/ADJ” button to enter programming mode.
4. Press PRE - or PRE + button to select the desired station memory for storage.
5. Press “PROG/ADJ” button again to confirm the setting.
6. Repeat steps 2 to 5 to store other stations.
7. Press PRE - or PRE + button to reload the preset stations in order.
8. The unit will return to normal TUNER mode if no buttons are pressed.
FM and FM Stereo Reception
Press the ST./MONO button on the remote handset to select “MONO” or
“STEREO” reception mode.
Hints for Best Reception
- AM: the receiver has a built-in AM bar antenna. If AM reception is weak, slightly
rotate or reposition the unit to improve the AM reception.
- FM: the receiver has an attached FM wire antenna at the back of the unit.
This wire should be fully unwound and extended at full length for best reception.
8