Filter
Top Products
3
GENERAL CONTROLS
1. Power Cable: This power cable should be plugged into a wall receptacle AFTER all audio
connections are made.
2. RCA Audio Output Cables:
These cables should be
plugged into the audio inputs of
your home stereo system.
(Please note: you can still copy
records to your computer, even
if the audio outputs of the
turntable are not connected to a
stereo system).
IMPORTANT: There is a switch
on the bottom panel, next to the
RCA cables, that selects
between PHONO/LINE. Use
PHONO level for plugging into
a turntable input on a home
stereo. Use the LINE level for
plugging into CD/AUX/TAPE
inputs.
WARNING: You may damage
your receiver if you plug in a
LINE level into a PHONO
input.
3. USB Audio Output: Use the
included USB Cable to connect
your turntable to your computer. For transferring your vinyl records to your computer, we
have provided two different software packages on the included CD.
4. Power Button: Turns the unit on and off.
5. Platter: This platter must be securely fastened to the turntable prior to operation. The
Motor Drive Belt can be found on the drive ring underneath the platter. See SETUP
INSTRUCTIONS for detailed information on installing the Motor Drive Belt.
6. Start/Stop Buttons: These buttons start and stop the turntable motor. Both buttons have
the same function. If they seem to not be functioning, check to make sure that the Motor
Drive Belt is properly installed in the SETUP INSTRUCTIONS.
7. 1/8” Stereo Line Input: Connect Tape Players, Reel to Reel, or any other audio source
here. This signal is sent to the computer through the USB. Make sure that your phono
cartridge is installed while using this input for maximum sound quality. Also make
sure that your RCA jacks are either plugged into an input device or not in contact with
metal.
Note: The 1/8" audio input is not routed to the turntable's RCA output jacks, only to your
computer via USB.
8. 33 and 45 RPM Buttons: These buttons control the RPM of the turntable platter. A red
LED indicates which RPM mode has been selected.
NOTE: If the turntable is powered down while in the 45 RPM setting, it will return to 33
RPM when it is powered up.
Note: You can record your 78RPM records by recording them at 33 or 45rpm, then
changing them to 78 in the Audacity software.