Filter
Top Products
6
CAUTION:
Using the System in the US
• Anychangesormodicationsnot
expressly approved by the grantee of this
device could void the user’s authority to
operate the equipment.
• This equipment must be installed and
operated in accordance with provided
instructions and the antenna(s) used
for this transmitter must be installed to
provide a separation distance of at least
20 cm from all persons and must not be
co-located or operating in conjunction
with any other antenna or transmitter.
End-users and installers must be provide
with antenna installation instructions
and transmitter operating conditions for
satisfying RF exposure compliance
• Outdoor operations in the 5150~5250MHz
band are prohibited.
• This device has no Ad-hoc capability for
5250~5350MHz and 5470~5725MHz.
• The device not operation in
5600~5650MHz.
• This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. this device may not cause harmful
interference, and
2. this device must accept any
interference received, including
interference that may cause undesired
operation.
Industry Canada Statement
This device complies with RSS-210 of the
Industry Canada Rules. Operation is subject
to the following two conditions: (1) This device
may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.
Radiation Exposure Statement:
This equipment complies with IC radiation
exposure limits set for an uncontrolled
environment. This equipment should be
installed and operated with minimum distance
20cm between the radiator & your body.
Caution:
1. the device for operation in the band 5150-
5250 MHz is only for indoor use to reduce
the potential for harmful interference to
co-channel mobile satellite systems;
2. High-power radars are allocated as primary
users (i.e. priority users) of the bands
5250-5350 MHz and 5470~5600MHz,
5650~5725MHz and that these radars
could cause interference and/or damage to
LE-LAN devices.
Under Industry Canada regulations, this
radio transmitter may only operate using an
antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry
Canada. To reduce potential radio interference
to other users, the antenna type and its gain
should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful
communication.
IMPORTANT NOTE:
• In the event that these conditions can
not be met (for example certain laptop
congurationsorco-locationwithanother
transmitter), then the Canada authorization
is no longer considered valid and the IC
IDcannotbeusedonthenalproduct.In
these circumstances, the OEM integrator
FCC Statement
The user is cautioned that this device should
beusedonlyasspeciedwithinthismanual
to meet RF exposure requirements. Use of
this device in a manner inconsistent with this
manual could lead to excessive RF exposure
conditions.