IOGear GWHDMS52 Satellite Radio User Manual


 
19
7. If operation is normal, the POWER/Wireless status LED and Source Status LED will glow in
solid green. Please refer to the LED status table below that contains detailed LED indicator
and OSD descriptions for the transmitter and receiver:
Item / Mode
Status
Description
Tx / Rx
Power
LED
Tx/Rx
Source
LED
Rx
Video
LED
Rx
Wireless
LED
OSD Display
Standby
For power saving
mode.
Static
Red
off off off
Initial Boot
up / Warm
up
It will spend 15 ~
20 seconds for
system boot up.
Tx
Blinking
Green
Rx Static
Green
Blinking Blinking Blinking
Searching
available
channels
Continuing search
available channels
If system can’t
establish link
over 80s after
initialization.
Tx
Blinking
Green
Rx Static
Green
Blinking Blinking
Wireless
linked Mode
No input from
selected source
(Note B)
Static
Green
Blinking
(Quickly)
Blinking
(Quickly)
Static
Green
Video format not
recognized
(Note C)
Static
Green
Blinking
(Slowly)
Blinking
(Slowly)
Static
Green
Video format is
recognized
Static
Green
Static
Green
Static
Green
Static
Green
-
Notes:
A. If the RF connection boot-up has exceeded 80 seconds and still not established a link
between the transmitter and receiver, it is due either to lost link or the transmitter is
most likely out of range. You may have to verify the range and adjust or shorten the
distance between your HDTV set with the transmitter and the receiver. The maximum
video transmission range for 1080p content is up to 100 feet in line of sight (LOS). The
minimum range is 6.5 feet.
B. Please make sure the source device has been powered ON and the signal output is set
to HDMI out; also try to re-plug the HDMI cable to make sure the HDMI connector had
seated properly.
C. If there is no video displayed and OSD display shows “Not Supported Format”, this is
an indication that the video resolution or frame rate from the computer is not supported,
please refer to page 26 to switch to a supported video resolution.
D. If you have more than one pair of this product, each transmitter and receiver should be at
least 6.5 feet away from one another.
4 levels
looping
Looping display
these two OSD
x
x