Filter
Top Products
18
Connecting the TUN-3.7
—Continued
You can use the following multi-room kits to control the
TUN-3.7 when it’s out of range of the remote controller:
• Multiroom AV distribution and control systems such
as those made by Niles
®
and Xantech
®
.
Controlling the TUN-3.7 When It’s Out of
Range
If the TUN-3.7 is located in another room, installed in a
cabinet, or out of range of its remote controller, you can
use a commercially available IR receiver to pickup the
remote controller signals and feed them to the TUN-3.7,
as shown below.
Connect the IR receiver to the TUN-3.7 as shown
below.
Controlling Other Out-of-range
Components
If another component is out of range of its remote con-
troller, you can use a commercially available IR emitter
to retransmit the remote controller signals received at
the TUN-3.7’s IR IN, as shown below.
Connect the IR emitter to the TUN-3.7’s IR OUT, and
place the IR emitter in front of the other component’s
remote control sensor (usually located on its front
panel), as shown below. See the instructions supplied
with the IR emitter.
Only remote controller signals received by the
TUN-3.7’s IR IN are fed through to the IR OUT. Signals
picked up by the TUN-3.7’s remote control sensor are
not output.
Controlling Components That Are Out of Range
IR IN
TUN-3.7
Inside
cabinet
Remote controller
Connecting
block
IR receiver
: Signal flow
TUN-3.7
from connecting block
Miniplug cable
IR IN
IR OUT
Connecting
block
IR receiver
TUN-3.7
IR emitter
Remote controller
Other
component
: Signal flow
TUN-3.7
Remote control
Other component
sensor
from connecting block
Miniplug cable
Miniplug
IR emitter
IR Emitter
:Signal flow