Filter
Top Products
39
First Time Setup
—Continued
■
Checking the Results
If you selected “Check the Results” in step 4 on the pre-
vious page, the following menu appears and you can
check the results of the automatic speaker setup.
1. Warning—
Undetected speakers and position warn-
ings (see the right column).
2. Speaker Config—
Connected speakers and crossover
frequencies.
3. Speaker Distance—
Distance from each speaker to
the listening position.
4. Speaker Level Adjust—
Optimum volume level for
each speaker.
5. Equalizer Settings—
Optimum equalizer settings for
each speaker.
Warning Messages
In the warning messages, abbreviations are used to iden-
tify the speakers (e.g., “L” for left, “R” for right, and so
on).
Not Detect:
The speaker was not detected. Make sure that it’s
connected properly.
Distance Error:
The speaker is either too close or too far away, or
the distance could not be measured. Reposition the
speaker.
Changing the Speaker Settings Manually:
In some situations, the measurements taken by the auto-
matic speaker setup may not provide usable results. If
running the speaker setup a second time still doesn’t pro-
vide usable results, you’ll have to set the speaker settings
yourself (see pages 63–67).
Using a Powered Subwoofer:
If you’re using a powered subwoofer, because it’s posi-
tioned low down on the floor and outputting very low
frequency sounds, its output may not be detected prop-
erly. If the subwoofer (abbreviation “SW”) appears on
the Warning screen under Not Detect, turn up the sub-
woofer’s volume and run the automatic speaker setup
again. If the subwoofer has a built-in crossover, set it to
the highest crossover frequency. If it has an LPF filter
switch, set it to off or direct. Refer to your subwoofer’s
instruction manual for details.
Use the Up and Down [ ]/[ ]
buttons to select the item that
you want to check, and then
press [Enter].
Press the [Return] button to return to
the previous menu.
Auto Speaker Setup
========================
1.Warning
2.Speaker Config
3.Speaker Distance
4.Speaker Level Adjust
5.Equalizer Settings
1.Warning
========================
Not Detect:
Distance Error:
2.Speaker Config
========================
Front :Small
Center :Small
Surround :Small
SurrBack :Small
SurrBack ch :---
Crossover : 60Hz
Subwoofer :YES
3.Speaker Distance
========================
Left :12.0ft
Center :12.0ft
Right :12.0ft
Surround R : 7.0ft
SurrBack : 7.0ft
Surround L : 7.0ft
Subwoofer :12.0ft
4.Speaker Level Adjust
========================
Left : 0dB
Center : 0dB
Right : 0dB
Surround R : 0dB
SurrBack : 0dB
Surround L : 0dB
Subwoofer : 0dB
5.Equalizer Setting
========================
========================
80Hz : 0dB
250Hz : 0dB
800Hz : 0dB
2.5kHz : 0dB
8kHz : 0dB
Channel: Left
When you’ve finished checking,
press the [Return] button to
return to the menu in step 4.
Auto Speaker Setup
========================
Apply the Results
Check the Results
Retry
Retry with
Test noise Level up
Cancel