Filter
Top Products
9
Insignia NS-R5100 AV Digital Home Theater Receiver
www.insignia-products.com
2 Load two type AAA batteries into the
compartment matching the polarity indicated.
3 Replace the cover.
Using the remote control
Use the remote control by pointing it towards the
receiver’s remote sensor window. Objects
between the remote control and sensor window
may prevent proper operation.
Use the remote control within about 23 feet
(7 meters) of the receiver and within 30 degrees
of perpendicular to the front of the receiver.
Using your receiver
After connecting power for the first time, set
up your receiver for optimum performance by
following the instructions in “Modifying the
settings” on page 17.
Listening to a program
To listen to a program:
1 Press the POWER button on the
receiver to put the receiver in
Standby mode. The STANDBY
indicator lights up.
2 Press the POWER ON button on the remote
control to turn the receiver on.
3 To hear sound from the speakers,
press the SPEAKER button to turn
the speakers on. The SPEAKER
indicator lights up and sound can be
heard from the speakers.
-OR-
To heard sound from headphones,
press the SPEAKER button to turn
the speakers off. The SPEAKER
indicator turns off and sound can be
heard from the headphones.
Note
Remove the batteries if they are not to be used for
a long period of time.
Caution
• Do not expose the remote control to shock. In
addition, do not expose the remote control to
liquids, and do not place in an area with high
humidity.
• Do not place the remote control under direct
sunlight. The heat may cause deformation of
the remote control.
• The remote control may not work properly if the
remote sensor window of the receiver is under
direct sunlight or strong lighting. In such a
case, change the angle of the lighting or
receiver, or operate the remote control closer to
the remote sensor window.
23’ (7m)
Tip
The following settings are stored in memory
before the receiver is turned off:
• INPUT SELECTOR settings
• Surround mode settings
• Preset stations.
Tip
You can turn the receiver off by pressing the
POWER button on the receiver while it is in
Standby mode.
Tip
You can put the receiver in Standby mode by
pressing the STANDBY button on the remote
control when the receiver is on.
Tip
With the receiver in Standby mode, you can also
turn the power on by pressing an Input Selector
button.
Note
• When listening to a DTS or Dolby Digital
program source, if the headphones are
plugged in and the SPEAKER button is set to
off, the receiver enters the 2CH downmix mode
automatically. For more information, see “2CH
downmix mode” on page 13.
• When EXTERNAL IN is selected as an input
source, only front left and front right channel
signals can be reproduced through the
headphones.
PRESETS