Filter
Top Products
5
TSS-SAT800
Step 4. Screw the ball and shaft assembly (B) to the lower
1/4"-20 insert on the rear of the satellite.Back out 1/2 of a turn
and tighten the nut against the speaker.
Step 5.Attach the speaker wire as shown on page 6.
Step 6. Drop round collar (C) over ball and shaft assembly (B)
that is mounted to the speaker with the finished side of the collar
facing the rear of the speaker.
Step 7. Carefully push the ball straight into the socket mounted
on the wall,angle the speaker as desired and tighten the collar
using the enclosed metal bar.
Figure 3.Bracket on wall.
Metal bar
®
ENGLISH