Filter
Top Products
4
TSS-SAT800
Using the Satellite on the Shelf Stand
To attach the satellite to the shelf stand, hold the satellite on top
of the stand and insert the two included screws through the rear
of the stand and into the rear of the speaker.
®
The TSS-SAT800 satellite is designed to be mounted on the
wall.There is a fixed-mount wall bracket and an adjustable wall
bracket provided for each satellite.Each speaker bracket will
require up to four 1-1/2"#10
wood screws;each screw should
be fastened to a wall stud.If a wall stud is unavailable,install an
anchor appropriate for a 1-1/2"
#10 screw.
NOTE:The customer is responsible for the correct selection
and use of mounting hardware (available through hardware
stores) that will ensure the proper and safe wall-mounting of
the speakers.
Fixed-Mount Wall Bracket
Step 1. Mark the positions on the wall where you would like to
place the mounting screws.
Step 2.Attach the back plate of the bracket to the wall using
three screws (not included).
Step 3.Attach the front plate (with the spring tab) of the bracket
to the satellite using the two provided screws.
Step 4. Slide the speaker with the
attached bracket front plate
onto the back plate of the
bracket until the tab locks into
place.
To remove the speaker
from the wall,simply push in the locking
tab and slide
the speaker up.
keyhole on the back of the speaker to the
screwhead on the wall.Once positioned
properly, the speaker should slide down slightly
and become secure.
WALL-MOUNTING THE SATELLITES
Adjustable Wall Bracket
Step 1. Mark the positions on the wall where you would like to
place the mounting screws.
Step 2. Place the bracket against the wall and fasten four
1-1/2" #10 wood screws through the bracket’s screw holes into
the wall.If a wall stud is not available,use an appropriate
anchor.
Step 3. Unscrew round collar (C) from bracket (A).
A
B
C