Filter
Top Products
4
TSS-SAT500
WALL-MOUNTING
The TSS-SAT500 satellite is designed to be mounted on the wall.
There is a wall bracket included.The speaker bracket will
require four 1-1/2" #10 wood screws;each screw should be
fastened to a wall stud.If a wall stud is unavailable,install an
anchor appropriate for a 1-1/2"#10 screw.
NOTE:The customer is responsible for the correct selection
and use of mounting hardware (available through hardware
stores) that will ensure the proper and safe wall-mounting of
the speakers.
Step 1.Detach shelf stand by removing screw in rear of speaker.
Step 2.Mark the positions on the wall where you would like to
place the mounting screws.
Step 3.Place bracket against the wall and fasten four 1-1/2"
#10 wood screws through the bracket’s screw holes into the
wall.If a wall stud is not available, use an appropriate anchor.
Step 4.Unscrew round collar (C) from bracket (A).
A
B
C
Step 5.Screw the ball and shaft assembly (B) to 1/4"-20 insert
on rear of speaker.Back out 1/2 of a turn and tighten nut
against the speaker.
Step 6.Attach speaker wire as shown on page 5.
Step 7.Drop round collar (C) over ball and shaft assembly (B)
that is mounted to the speaker with the finished side of the
collar facing the rear of the speaker.
Step 8.Carefully push the ball straight into the socket mounted
on the wall, angle the speaker as desired and tighten the collar
using the enclosed metal bar.
.
Figure 3.Bracket on wall.
Metal bar
®
TSS-SAT500 OM 11/14/05 4:14 PM Page 4