Filter
Top Products
3
TSS-800 (120V)
A
djustable Wall Bracket
S
tep 1.
M
ark the positions on the wall where you would like to
place the mounting screws.
Step 2. Place bracket against the wall and fasten four 1-1/2"
#
10 wood screws through the bracket’s screw holes into the
wall. If a wall stud is not available, use an appropriate anchor.
Step 3. Unscrew round collar (C) from bracket (A).
A
B
C
Step 4. Screw the ball and shaft assembly (B) to the lower 1/4"-
20 insert on the rear of the satellite, or the upper insert on the
rear of the center channel. Back out 1/2 of a turn and tighten
the nut against the speaker.
Step 5. Attach speaker wire as shown on page 4.
Step 6. Drop round collar (C) over ball and shaft assembly (B)
that is mounted to the speaker with the finished side of the
collar facing the rear of the speaker.
Step 7. Carefully push the ball straight into the socket mounted
on the wall, angle the speaker as desired and tighten the collar
using the enclosed metal bar.
Figure 3. Bracket on wall.
Metal bar
®
®
®
TSS-800 (120V) OM 2/24/06 10:01 AM Page 8