Filter
Top Products
ii
TSS-800 (120V)
Read First!
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as
radiators, heat registers, stoves or other apparatus
(inc
luding amplifiers) that produce heat.
9. Do not defeat the safety purpose of the
polarized or grounding-type plug.A polarized plug
has two blades with one wider than the other.A
grounding-type plug has two blades and a third
gr
ounding prong.The wide blade or the third
prong are provided for your safety. If the provided
plug does not fit into your outlet, consult an
electr
ician for replacement of the obsolete outlet.
10. Pr
otect the power cord fr
om being w
alked on
or pinched, particularly at plugs, convenience
receptacles and the point where they exit from the
appar
atus.
11. Only use attachments/accessories specified by
the manufacturer.
12. Use only with the cart, stand, tripod, bracket or
table specified by the manufacturer or sold with
the appar
atus.When a cart is used, use caution
when moving the cart/apparatus
combination to avoid injury from
tip-o
v
er.
13. Unplug this apparatus during
lightning storms or when unused for
long periods of time.
14. Refer all servicing to qualified service
personnel. Servicing is required when the
a
pparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the
a
pparatus, the apparatus has been exposed to rain
or moisture, does not operate normally, or has
been dropped.
15. Do not use attachments not recommended by
the product manufacturer, as they may cause
hazards.
16. T
his product should be operated only from the
type of power sour
ce indicated on the marking
label. If you are not sure of the type of power
supply to your home, consult your product dealer
or local power company
. For products intended to
operate from battery power, or other sources, refer
to the operating instructions.
17. If an outside antenna or cable system is
connected to the product, be sure the antenna or
cable system is grounded so as to provide some
protection against voltage surges and built-up
static charges.Article 810 of the National
Electrical Code,ANSI/NFPA 70, provides
information with regard to proper grounding
of the mast and supporting structure, grounding
of the lead-in wire to an antenna discharge
unit, size of grounding conductors, location of
antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding
electrode. See Figure A.
18. An outside antenna system should not be
located in the vicinity of overhead power lines or
other electric light or power circuits, or where it
can fall into such power lines or circuits.When
installing an outside antenna system, e
xtr
eme
car
e should
be taken to keep fr
om touching such
power lines or circuits,as contact with them might
be f
atal.
19. Do not overload wall outlets, extension cords,
or integral convenience receptacles, as this can
r
esult in a risk of fire or electric shock.
20. Never push objects of any kind into this
p
roduct through openings, as they may touch
dangerous voltage points or short-out parts that
could result in a fire or electric shock. Never spill
liquid of any kind on the product.
21. The apparatus shall not be exposed to dripping
o
r splashing, and no objects filled with liquids,
such as vases, shall be placed on the apparatus.
22. Do not attempt to service this product yourself,
as opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
23. W
hen replacement parts are required, be sure
the service technician has used replacement parts
specif
ied by the manufacturer or that have the
same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock or other hazards.
24. Upon completion of any service or repairs to
this product, ask the service technician to perform
safety checks to determine that the product is in
proper operating condition.
25. The product should be mounted to a wall or
ceiling only as recommended by the manufacturer.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: To reduce the risk of electric shock,
do not remove cover (or back).
N
o user-serviceable parts inside.
R
efer servicing to qualified service personnel.
CAUTION: To prevent electric shock,
do not use this (polarized) plug with
a
n extension cord, receptacle or other outlet
unless the blades can be fully inserted to
prevent blade exposure.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
a
lert the user to the presence of uninsulated
“dangerous voltage” within the product’s
e
nclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons.
F
igure A.
Example of
Antenna Grounding as per
National Electr
icalCode ANSI/NFPA 70
IMPORTANT SAFETY PRECAUTIONS
TSS-800 (120V) OM 2/24/06 10:01 AM Page 4